Introduction
Vacuum cleaners are essential household appliances, and one of the most important parts of their operation is turning them on.
How to Turn on the Vacuum Cleaner?
Instructions:
To turn on the vacuum cleaner, first make sure the power is off at the outlet. Then locate the switch to turn on the vacuum cleaner. To do this, look for a round switch near the floor. There are also switches located near the front of the vacuum cleaner. Push down on either switch until it clicks into place.
How to Put the Vacuum Cleaner in the Auto Mode?
When you’re ready to put your vacuum cleaner in the auto mode, follow these Vacuum cleaner Supplier simple steps:
1. Open the lid of the vacuum cleaner and locate the switch that is labeled "Auto." The Auto setting will automatically turn on your vacuum cleaner when you plug it in to an outlet.
2. If you want to manually control the vacuum cleaner, locate the switch that is labeled "Auto/Manual" and toggle between the two settings.
image source: https://www.pinterest.ph
How to Put the Vacuum Cleaner in the Handheld Mode?
How to Put the Vacuum Cleaner in the Handheld Mode?
When you're ready to vacuum, put your vacuum cleaner in the handheld mode by pressing the center of the power cord against the back of the unit. Turning the Handheld vacuum cleaner on with the handheld mode will save energy and time.
image source: https://www.pinterest.ph
How to Change the Filter on a Vacuum Cleaner?
If you have a vacuum cleaner with a filter, it is important to change the filter often. The filter helps to prevent dirt and dust from getting into the vacuum cleaner motor and hoses. Here are instructions on how to change the filter on most types of vacuums.
1. Check the manufacturer's instructions to see if there is a specific way to change the filter on your particular model of Wet&Dry vacuum cleaner.
2. If there is no specific way to change the filter, remove the old filter by unfolding it and pulling it out.
3. Wash your hands well before touching any part of the vacuum cleaner, including the filters.
4. Place the new filter in the correct position and screw it in place with a screwdriver or a wrench.
5. Plug in your vacuum cleaner and turn it on.
