Introduction
This article will cover the configuration of a metering pump in a single beam non woven making machine. Strong bonds hold a continuous fiber network of incredibly small filaments together to create nonwoven fabric. The dye is dispersed in the liquid dispersion medium using the metering pump before being applied to the nonwoven fabric.
Source: https://i.pinimg.com
How to configure metering pump in a single beam nonwovenmachine
Metering pumps are used in non woven fabric machine to regulate the speed at which the fabric is pulled through the machine. The metering pump controls how much fluid enters the cloth and flows through the pump. The end product's thickness and quality can be adjusted by adjusting the fabric's pace.
To set up your metering pump, do the following:
Wait for your machine to reach operating temperature before turning it on.
Open the panel on the machine's front where the metering pump is located.
By removing the mounting screws, you can remove the old metering pump.
Utilizing mounting screws and screws, install the new metering pump.
All tubing and wiring should be reconnected as needed.
Test your machine by drawing a sample fabric through it.
Source: https://i.pinimg.com
Conclusion
The metering pump arrangement in a single beam non woven machine will be covered in this article. You will be able to set the metering pump and enhance its performance after reading this article.
